MIDLAND BT City - Manual (Page 25)

UK
9
Some manufacturers radios use a different pin configuration, so we
recommend that you ask your dealer as to which cable is best suited
to your needs.
To communicate via the attached radio, press the transmission Press
To Talk (PTT) button to speak and release it to listen. It is not possible
to talk and listen simultaneously. Communications can be activated
also without pushing the PTT button, by enabling the VOX function.
Special configurations
Some Midland BTCity/BTEva features can be configured to suit specific
needs:
› Adjusting/ Disabling the VOX feature (Intercom and telephone)
› Wired connection always on
› Intercom and GPS
Adjusting/ Disabling the VOX feature
(Intercom and telephone)
The Intercom feature can be enabled both manually and vocally
(VOX). The VOX activation is influenced by the background noise and
therefore by the speed.
For optimum results, it is possible to choose one of the following four
microphone sensitivity levels: high, medium, low and very low. The
default setting of BTCity/BTEva is “low”. It is also possible to disable
the VOX feature in order to activate the Intercom and phone call an-
swering features in manual mode only.
Adjusting the sensitivity of the microphone (VOX)
1. Enter the Setup mode: Switch your BTCity/BTEva off.
Press and hold down the central button (Control) until the red in-
dicator switches on permanently. Your BTCity/BTEva is now in “Set
up mode”.
2. Press the “Volume+” and “Control” buttons till the red indicator
will turn to steady blue.
3. Now, press “Volume +” or “Volume -“to increase or reduce sensi-
tivity. Every time you press the Volume buttons the RED light will
flash for confirmation. When you reach the end of the upper and
lower limit, the RED light will not flash.
4. Double press the “Control” button; the Blue light will flash several
times, in order to let you know the selected sensitivity:
once = VOX disabled
Twice = very low sensitivity
3 times= low sensitivity
4 times= medium sensitivity
5 times = high sensitivity
Default = low sensitivity
5. The light indicator is now back to steady RED (“Set up mode”) and
the changes are confirmed
6. If needed, you can adjust again the sensitivity repeating the steps
from point 2, otherwise exit the Setting mode by double clicking
the “Control” button. Once the red light turns off, the blue led
starts blinking. Now you can use your BTCity/BTEva.
Disabling the VOX feature (Intercom and telephone)
Follow all the procedure described in the previous steps and choose
the option 1 (VOX disabled). You will see the blue led blinks once.
Wired connection always on
This feature let you keep the wired connection always on, even when
the phone or the intercom is open. This feature can be useful when
you connect a PMR446 transceiver.
Enabling:
› Enter the “Setup” mode.
› Press the “Volume+” and “Volume -” buttons for one second. The
blue LED will flash once.
› To exit the “Setup” mode double press the “Control” button.
Disabling:
› Follow the same procedure up described; now the blue LED will
flash twice
› To exit the “Setup” mode double press the “Control” button.
Intercom and GPS
Disabling:
› Enter the “Setup” mode.