MIDLAND G9 - Manual (Page 19)

19
EN
GL
IS
H
buttons.
Confirm your selection by pushing PTT or wait for 5 seconds.
Display illumination
If there is insufficient light to read the display, press briefly EMG and the display illumination will activate for about
5 seconds. Every time the MENU is pressed, the display will automatically light up.
Power save
The battery power saving feature enables a reduction in the consumption of up to 50%; power saving comes on
automatically when the transceiver does not receive any signal for more than 7 seconds. When the batteries are
discharged, the icon
CALL
MENU
EMG
1
2
5
3
4 6 8 7
11
9
10
12
13
14
15
24
23
22
21
20
19
18
17
16
appears on the display: replace the batteries or recharge the battery pack.
! The power save is active only if the Emergency function is disabled.
Battery recharge
Connect the socket of the wall adaptor to a mains power socket and insert the jack of the wall adaptor into the
desktop charger plug. It takes 12/14 hours to fully recharge.
Place your transceiver into the cradle of the desktop charger. The red led of the charger will light up.
When charging is complete take the transceiver out of the cradle and detach the socket of the wall adaptor from
the mains.
! Do not overcharge the batteries! When these are fully charged the charging process does not stop
automatically. Do not forget therefore, to remove the transceiver from the charger as soon as the
batteries are charged, otherwise the radio and batteries may be damaged.
! Do not try to charge alkaline batteries or non rechargeable batteries. Make sure that when you charge
the radio, only rechargeable NI-MH batteries or the supplied battery pack should be contained in the
battery compartment! Alkaline batteries are not rechargeable! Batteries which are not suitable to be
recharged may leak, explode or even burn and cause damage!
! Using a different battery charger other than the one specified can cause damage to your device or may
even cause explosions and personal injuries.
! Do not throw batteries into fire or place them near heat as this may cause explosions or personal
injuries. Dispose of the batteries according to the procedures set out by local regulations.
! Do not mix old and new batteries or batteries of different types or batteries which have been used in
different manners.