MotorVac TRANSTECH IV - Manual (Page 14)

[email protected] www.motorvac.com 11
Dipstick Exchange (Cont’d)
7. The DRAIN light is on solid. Initial drain cycle begins.
8. Once fluid flow has stopped, service pauses, FILL light flashes. The operator can continue with service
or remove the drain pan if drain pan service is required.
9. Press FILL button to continue service. The unit will refill the same amount of fluid that was drained from
the transmission oil pan. After the initial Fill sequence, the unit will pause and the START ENGINE light
will flash.
10. Start the engine.
11. Press the START/RESUME button to continue the service to completion.
12. The COMPLETE light will turn on when the service is complete and alarm will sound. Press STOP button
to silence alarm.
13. Remove the Dipstick fill adaptor and check the level of transmission fluid in the vehicle.
14. If the transmission fluid level needs adjustment, re-insert the dipstick fill drain tube back into the vehicle
and adjust the fluids as necessary by pressing the DRAIN or FILL buttons.
15. Direct waste hose to a suitable container; open the ball valve on the end of the waste hose and press
EMPTY WASTE to empty dirty fluid tank.