MP Pumps FRX-75 SP INSTALL - Manual

Model FRX 75-SP is a high performance
selfpriming 316 stainless steel centrifugal pump.
The pump is ideal for marine, industrial,
agricultural or commercial applications where
suction lift is required.
The FRX 75-SP model features all 316 stainless
steel components for superior corrosion
resistance when pumping chemical compounds.
A carbon / ceramic / viton bellows seal is
standard. Ports are 3/4" with 1/8" NPT fill port.
The FRX 75-SP model is capable of 12 foot suc-
tion lift (3450 rpm).
®
®
FORM 3807A (08-06)
FRX 75-SP STAINLESS STEEL CENTRIFUGAL PUMP
INSTALLATION, OPERATION, AND REPAIR MANUAL
GENERAL SAFETY INFORMATION:
THE FOLLOWING WARNINGS ARE USED TO NOTIFY AND ADVISE THE USER OF THIS PRODUCT OF
PROCEDURES THAT MAY BE DANGEROUS TO THE USER OR RESULT IN DAMAGE TO THE PRODUCT.
THIS BULLETIN MUST BE READ COMPLETELY BEFORE INSTALLING, OPERATING, OR SERVICING,
THE PUMP.
INSTALLATION:
For optimum performance, place the pump as close to the liquid as possible to minimize suction
lift. For best results, the pump should be installed no more than 10 feet above the liquid supply.
The motor is splash resistant, not submersible, and should be located in a dry environment.
• DO NOT perform service or maintenance
when the pumping system is pressurized.
Injury or death may occur.
• DO NOT operate the pump in a manner
that it was not intended to be used.
• DO NOT mount the pump such that high
piping loads exist on the pump flanges, or
in a rigid piping system that does not allow
the pipe to expand and cause the pump to
be strained.
• DO NOT continue to operate the pumping
system when a known leak exists.
• DO NOT continue to operate the pump
when unusual noise or vibration occurs.
• DO NOT operate beyond the pressure or
temperature limits stated in the product
literature. See Form 8110.
• DO NOT allow severe temperature changes
to occur in a short time period within the
pumping system.
Patent Pending