MPM MBL-01M - Manual (Page 15)

15
GB
Insert the gasket onto the jar. 2.
Turn over the base of the jar (6) with the cutter (5) and insert onto the blender jar (3). 3.
Tighten the blender base to the blender jar, previously checking for correct thread fit- 4.
ting.
NotE:
Do not install or remove the blender jar in course of appliance operation.
use oF tHe appLiance
- Cut the products into smaller pieces in order to facilitate the grinding
- Put the products into the jar only if the appliance motor is stopped (OFF)
- Precisely install the jar on blender housing
- Install the jar lid and hold it in course of the whole mixing sequence.
- Switch on the appliance by means of the switch (1) selecting one of two mixing speeds
- After mixing, pour the jar content into other containers.
NotE:
Some products e.g. ice cubes should be ground by multiple use of PULSE function. This
function is activated after the rotation of the switch knob to its extreme LH position and
its holding in this position or by the depressing of the pushbutton under the knob.
remarks concerning tHe appLiance use
ľ 1. cooked vegetables and decoction should be allowed to cool down before their pouring
into the blender jar.
In order to prevent any overloading or overheating, switch over to higher speed when 2.
the slowdown of the appliance commences.
Heavy sauces, pastes, mayonnaise or similar substances with similar consistence can be 3.
poured into the plates or storage containers after previous removal of the jar base.
Any liquid or semi – liquid substances like dough and light sauces can be poured through 4.
the top part of the jar after previous removal of the jar lid.
The blender has been not designed for the execution of the following activities: 5.
- grinding of potatoes
- beating of eggs or dairy products equivalents
- grinding of raw meat
- beating or mixing of heavy types of dough (potential danger of lumps formation which
may lead to the damage of the appliance).
- filtering off the fruit and vegetables juice.
6. The consistence of the components being mixed should be checked every few seconds
7. The maximum permissible operation time specified in the user manual should be not
exceeded.
8. In case of the motor stoppage, the mixing should discontinued immediately or the vol-
ume of products in the jar should be reduced.
9. In order to improve ice cubes grinding, a little amount of water can be added
10.Do not remove the jar from the housing in course of the appliance operation
11. Do not put any objects into the jar in course of mixing sequence.
MBL-01.indd 15 12-01-09 13:24:40