MPM MPR-03 - Manual (Page 10)

10
GB
UNIT'S DESCRIPTION
1. Switch ON/OFF
2. Ceramic plates
3. Temperature controller, range 80-230'C
4. Thermostat control light
5. Rotary cable
6. Button of the straightener opening blockade
7. Hanger
8. Case
HOW TO USE
Note! In order to obtain possible best effect, wash, brush and dry hair until it is little wet
1. Plug the unit. Put it on a smooth, dry and flat surface.
2. Switch the straightener using the switching on button (1) ON. Set required temperature – 80'C,
110'C, 230'C or other temperature due to the temperature controller (3). Thermostat control
light shall shine (4). Wait until the straightener reaches the required temperature which shall be
signalized by the thermostat control light – it goes out (4).
3. Set lower temperatures in case of thin hair, dyed or damaged hair. Set medium temperatures in
case of wavy hair. Set high temperature in case of thick hair, very thick or naturally curled hair.
4. Start from the peak of head, take some hair (approx. 5 cm wide) and insert the hair between
ceramic plates. Move the unit from hair bulbs to their ends. Avoid contact between head or hands
and hot plates. Rotary power cable (5) enhances comfort of operation. Ceramic plates (2) enhance
hair styling.
5. Repeat the above-described operation for all hair. Wait until hair has cooled down before brushing
out.
6. After use is over switch the unit off using the OFF button (1).
7. After cooling down wipe the unit out using a wet cloth. Do not use chemical agents.
8 Straightener is equipped with a blockage button – blocking and unblocking. Straightener may
be closed and blocked in closed position due to the button on the left (6). In order to de-block the
straightener one needs to push the same blockade button on the right.
9. After the operation is over hang the straightener using the hanger (7).
2
4
1
3
6
5
7