MPM ss-1803 - Manual (Page 9)

9
GB
INSTRUCTIONS ASSOCIATED WITH USE SAFETY
► Read the operating instructions carefully before use.
► Do not hold the hairdryer with wet hands!
► Keep the appliance away from water!
► Do not submerge the appliance, power cord or plug in water or other liquids!
► Be especially careful when there are children around the appliance!
► Do not hang the power cord on sharp edges and do not allow it to touch hot surfaces.
► The appliance must not be used if damaged, including if the power cord or plug is damaged - if it
is then take the appliance to an authorised service point.
► Use of accessories not recommended by the manufacturer may result in damage to the appliance,
fire or injury.
► Always unplug the appliance after drying hair or before cleaning it.
► Do not use the hairdryer in the bath!
► If the appliance accidentally falls in water, unplug it immediately!
► Never leave the appliance on unsupervised!
► Do not place the appliance on hot surfaces.
► When drying take care that hair does not become entangled in the air duct.
► This appliance is not intended for the use by persons (including children) with limited physical,
sensory or mental abilities, or persons inexperienced or unfamiliar with the appliance, except
under supervision or in accordance with the instructions for use communicated by persons
responsible for their safety.
► Hot air must not be aimed at the eyes or other delicate areas.
► Do not wrap the power cord around the appliance!
► This appliance is intended for domestic use only.
► Never cover the air inlet or outlet!
► Do not allow children to play with the appliance.
► Never use the hairdryer near water in the bath, bowls or other vessels.
► When the hairdryer is being used in the bathroom, unplug it immediately after use as the vicinity
of water is a danger even when the dryer is switched off.
► For additional protection, it is recommended that bathroom electric circuit is protected by a
residual-current device (RCD) detecting the leakage current of at least 30 mA. See a specialist
electrician about this.