MPM MUG-03 - Manual (Page 10)

10
GB
APPLIANCE DESCRIPTION
1. Hot air outlet
2. Power switch
3. Termostat knob
4. Air inlet
5. Feet
bEFORE YOU USE:
1. Please assemble the feet and the body in the order given in the picture below:
2. Place the convector on the flat desk or carton.
3. Insert the 2 position fins of the feet into the position holes of the body .
4. Tight the fixed screw to connect body .and feet.
HOW TO USE THE UNIT
1. Please check before you use:
A: The heating wire and electric wire can not be broken.
B: Please do not use the socket lower than 10A for fear of any accident.
2. Use the convector on the flat place to avoid being toppled.
3. There are 3 selections.
-. 0 is no power working.
-. II is only 2000W.
-. I is only 800W.
4. There is a thermostat knob for adjusting heating. You can rotate the knob to get your desired
heating level.
5. If you stop using convector, turn off all the power switch, then put off the plug.
6. If you want to move the convector, please turn off the switches, then put off the plug, and hand
on the handle on the back of the convector.
1
2