MPM MOD-04 - Manual (Page 18)

1
GB
ASSEMBLY
1. Place the suction hose fastener (21) into the connection hole (18). The locking is signalled by a
click. In order to disassemble those elements, press two buttons on the fastener and remove the
suction hose from the hole.
2. Connect the aluminium telescopic pipe (2) to the grip (22) (to the other end of suction hose). Put
one of the suction nozzles on the end of suction pipe. Crevice nozzle with a removable (8) and
small dust brush (9) are placed in a special container for accessories (15). In order to access it,
lift the container's cover. Extend the telescopic pipe to a desired length by pressing the blocking
button (19) and then release the button. The suction pipe will be locked in a desired position.
OPERATION
1. Before switching on the vacuum cleaner, unwind the cord and insert the plug into the socket.
Yellow marking on the cord indicates an optimal length. Do not unwind the cord beyond the red
marking! When unwinding the cord, do not press the cord winder button(3).
2. Press the button (4) to switch the vacuum cleaner on.
3. To wind the power cord, press the cord winder button (3) with one hand and hold the cord with
the other hand to prevent a sudden movement, which may damage the cord.
Notice! It is advised that the suction power regulator (1) be set at MIN before switching on the
vacuum cleaner! When vacuum cleaning, the suction power can be adjusted by turning around the
suction power regulator to reach a desired position. If the suction pipe jams or a dust bag is full,
the dust bag filling indicator will change to red. Replace the dust bag or unblock the suction pipe.
Suction power can be adjusted with the suction power slide (17). To reduce the suction power, pull
the slide slightly.
4. To facilitate storing the vacuum cleaner after use, use the guide (22) placed at the back of the de-
vice over the filter cover (13). Place the rail located at the back of the floor/carpet nozzle together
with the suction hose and suction pipe on the guide. The second guide, which facilitates storing
the vacuum cleaner in the vertical position, is placed at the bottom of the device. To facilitate
carrying around, use an ergonomic grip (16)
desCriPtiOn Of aCCessOries:
floor/carpet nozzle:
- intended for cleaning large and flat surface. To facilitate cleaning, the vacuum cleaner is equip-
ped with rollers, which improve movability in areas, which are hard to access, and a flexible joint
connecting it with the suction hose which help to use it at different angles.
- after pressing the button on the upper part of the nozzle (switching to the ”brush mode”), several
rows of rigid hair and a rubber stripe will appear to facilitate cleaning of carpets
Crevice nozzle with a removable brush:
- used to clean the corners, areas near the furniture as well as bends and gaps. Great for cleaning
computer keyboards, drawers, radiators and window frames
- by putting the hair bush on the nozzle, we can use the tool to clean window curtains, furniture,
upholstery, creases on upholstered furniture (sofas, couches, fragile elements such as lampsha-
des)
emPtying tHe dust bag:
To empty the dust bag, disconnect the device from the mains, remove the suction hose fastener (21)
and lift the upper cover (6) having pressed the button (12)