MPM MOD-03 - Manual (Page 22)

22
GB
BEFORE USE
ATTENTION: Make sure that the device is disconnected from mains.
Disengage the clamps (B5) (drawing 1). Lift an engine’s set using an attached handle and
-
take out a water filter tank (B2) (drawing 2).
Next take accessories out and put them in a handle (D1).
-
While unpacking check if there are all parts and if they are not damaged.
-
Make sure that a foam filter (A7) is located in float chamber (A6).
-
Put wheels (B7) on a bottom part of water container (B1) (drawing 3).
-
Fix water filter tube (B4) (drawing 4), through rubber gasket (B8) (drawing 5).
-
Next put water filter tank (B2) into water container (B1) (drawing 6).
-
Put into the tank (B2), water filter sponges (B3) (drawing 7, 8).
-
Put engine’s set on the container and fix using clamps (B5) (drawing 9, 10).
-
DIRECTIONS FOR USE
To ensure the highest comfort and safety a vacuum cleaner has been equipped with a
water filter. It is a specially designed device whose role is to absorb the tiniest particles of
dust and dust mites with the use of physical properties of water. Principle of water filter
operation is that the air sucked into the vacuum cleaner goes through a water container,
leaving all dust and dust mites in it.
Make sure that the device is disconnected from mains.
-
Check if the container, tubes and a hose are dry and without any dirt.
-
Disengage clamps and lift the engine’s set using a handle.
-
Take off water filter tank and fill in the container with clean water (max. 2l) (drawing 15).
-
Put the water filter tank on.
Put an engine’s set back on the device and lock the clamps.
-
Connect a sucking hose (C1) (drawing 11), using a connecting element (C4) of sucking
-
inlet of the vacuum cleaner (B6). Additional accessories can be attached to telescopic
sucking tube (C5) or directly to a handle (C2) depending on what you are going to do.
Connect the device to the mains.
-
Use a switch (A1) to switch a vacuum cleaner on.
-
To ensure freshness of air in the room add some drops of freshener (D5) to water in the
-
container (B1).
Using the equipment described above you can clean:
Floor and carpet head (C7) used to remove dust from carpets, rugs and hard floor surfaces.
-
It is equipped with rings allowing easier handling and a button. After pressing the button
you can adjust the head for hoovering hard surfaces, for example floors, parquets.
Attachment for cracks (D2) is used to clean places that are not easily accessible.
-
Telescopic sucking tube (C5) is used to suck earth, chips, crumbs and fur.
-
Narrow brush (D4) and round brush (D3) can be used to remove dust from shelves,
-
books, lampshades, frames, decorations, curtains etc.
The device has an air blow function. You can use this function in order to dry objects or to
-
clean stuck washbasin or bath. Connect a sucking hose to cover of HEPA filter case (A4)
(drawing 12) and next switch the device on. You can use a round brush for cleaning if you
remove a part with bristle before.
mod-03_instrukcja.indd 22 26-11-08 14:39:47