Multichannel Systems TC01-2 Manual - Manual (Page 13)

Installation and Operation
9
3.3.2 General User Interface
The display shows the actual temperature and the setpoint temperature. You can enter the next
menu levels by pressing the Select button. Go to a menu command with the Up and Down
buttons and press Select to select the command highlighted by an arrow and to enter the next
menu level. The functionality of the button array on the front panel is described in the following.
Up Goes to the menu command above or increases the
displayed parameter value. Tip once to increase the value
in a small single step, press longer for larger steps.
Down Goes to the menu command below or decreases the
displayed parameter value. Tip once to increase the value
in a small single step, press longer for larger steps.
Select Press this button to switch from Temperature Control
view to the Main menu. Selects the command
highlighted by an arrow in the menus and enters the
next menu level.
Back Leaves the menu level and goes back to the next higher
menu level. Settings that were selected or modified are
applied and saved automatically when leaving a menu.