Multichannel Systems MFP12 Manifold - Manual

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2013 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
MFP12 Manifold
multi
channel
systems
*
12-fold Manifoldplate for the Roboocyte2
12-fold manifold with two magnets on the bottom side for
fixing the manifold to the RoboFlow liquid handler device
belonging to the Roboocyte2 robot.
Please connect the manifold via magnetic forces to the
slide of the RoboFlow.
Use silicon tubes with an inner diameter of 0.8 to 1.2 mm.
Please connect one end of the tubes to the manifold tube
connectors, the other end via RoboFlow pinch valves to the
compound bottles. If you use only some of the twelve tubes,
please connect the useless tubes to Ringer solution, for
example, but do not leave the manifold connections open.
The main tube of the manifold leads via inlet perfusion
pump to the measuring head of the Roboocyte2.
Adjust the manifold in a deviation of about 15 degrees
to minimize the distance to the tube connection.
Roboocyte2 RoboFlow
Dimensions
Base plate
W x D x H: 42 x 42 x 10 mm
(without tube connectors)
Tube connectors
L x diameter: 3.5 x 1.75 mm
Magnets
Diameter: 10 mm
Distance from center to center
between both magnets: 25 mm