Multichannel Systems SD-MEA - Manual

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
2012 Multi Channel Systems MCS GmbH
Product information is subject to change
without notice.
SD-MEA
multi
channel
systems
*
+
GND
–
GND GND GND
GND GND GND
67 68
65 66
63 64
61 62
59 60
1
10 9
8 7
6 5
4 3
2
68-pin MCS standard connector
67 68
65 66
63 64
61 62
59 60
1
10 9
8 7
6 5
4 3
2
A1
A2
A3
A4
Use and Operation of the MEA Signal Divider
The MEA Signal Divider is used for picking single channels from the MEA amplifier. It is connected to
the MEA1060 amplifier and to the MC_Card or to an USB-ME-System with 68-pin MCS high grade cables.
The pin layout follows the MEA layout. It does not matter to which socket the input or the output is connected.
Four BNC connectors are available for connecting analog signal sources (A1 to A4).
The supply voltage inputs are not used for this device, but may be used for custom setups without IPS10W.
An external power supply can be connected to the SD-MEA, which passes the power to other devices of
the system, for example, to a MEA1060 amplifier. The input supply voltage can range from 6 V to 12 V.
68-Pin MCS Standard Connector
Pin 1 GNDP (power ground)
Pin 2 GNDS (signal ground)
Pin 3 to 62 Channels 1 to 60
Pin 67 Positive voltage supply
Pin 68 Negative voltage supply
67
68
65
66
63
64
61
62
59
60
1
10
9
8
7
6
5
4
3
2
!
Warning: The device may only be used together with MEA-Systems from Multi Channel Systems
MCS GmbH, and only for the specified purpose. Damage of the device and even fatal injuries
can result from improper use.
Scope of Delivery: MEA Signal Divider and 4 x 2 mm plug connectors (for soldering your own laboratory cables)
Pin 63 to 66 Channels A1 to A4