Multichannel Systems ADPT-FM-72 - Manual

Multi Channel Systems
MCS GmbH
Aspenhaustrasse 21
72770 Reutlingen
Germany Fon +49-7121-9 09 25- 0
Fax +49-7121-9 09 25-11
[email protected]
www.multichannelsystems.com
© 2012 Multi Channel Systems MCS GmbH
Product information is subject to change without
notice.
Scope of delivery:
1 FlexMEA72 adapter ADPT-FM-72
6 Button head srews M2x5 mm, washers, screw nuts
2 Bars
ADPT-FM-72
Warning: The adapter ADPT-FM-72 may only be used together with a FlexMEA72 and
with MPA32I from Multi Channel Systems MCS GmbH, and only for the specific purpose.
Damage of the device and even injuries can result from improper use.
FlexMEA adapter
for connecting two MPA32Is to the FlexMEA72
ADPT-FM-72: The adapter is equipped with the connectors for the MPA32Is on one side and the connectors
for the FlexMEA72 on the other side.
MPA32I: The side with no screws is considered to be the top side of the MPA32I. The MPA32Is have to be
connected with their top sides facing to each other (to the inner part of the adapter) and the bottom sides
facing outwards.
FlexMEA72: On the FlexMEA72 the side with the writing “NMI” is the side with contact pads and electrodes.
This side is optically golden shimmery and the letters “NMI” are readable.
Plastic Spacer: The spacer between FlexMEA72 and drawers ensures the contact from the printed circuit
board of the adapter and the contact pads.
Plastic Spacer
Adapter ADPT-FM-72 connected to both MPA32Is.
Connector for FlexMEA72
Connector for FlexMEA72
Connector
for MPA32I
No. 2
Connector
for MPA32I
No. 1
Connectors
for
FlexMEA72
GND
Connector
ADPT-FM-72
FlexMEA72