American DJ DMX - Manual (Page 7)

American DJ ® - www.americandj.com - Dynasty Scan DMX Instruction Manual Page 14 American DJ ® - www.americandj.com - Dynasty Scan DMX Instruction Manual Page 13
Dynasty Scan DMX Lamp Replacement
Caution: Always replace with the exact same type lamp and fuse,
unless otherwise specified by an authorized American DJ
®
service
technician. Replacing with anything other than the specified part can
damage your unit and will void your manufactures warranty.
Warning: If you continue to blow lamps or fuses, STOP using the
unit. Contact customer support for further instructions, you may have
to return the unit for servicing. Continuing to use the unit may cause
serious damage.
Lamp Replacement: Caution! Never attempt to change the lamp
while the fixture is plugged in. Always disconnect the main power
and allow the unit ample time to cool before attempting to replace
the lamp. Lamp replacement has been made simple by incorporating
slide out lamp assembly that is retained by two phillips screws.
1. Be sure to follow the proper handling procedures that deal with
halogen lamps.
2. Loosen the small screw located on the front of the unit
3. After loosening the screw, remove the socket assembly cover to
expose the lamp.
4. Carefully remove the old lamp and discard it in the trash.
5. Replace the lamp with an exact match and reassemble in reverse
order.
Halogen Lamp Warning: This fixture is fitted
with halogen lamps which are highly susceptible
to damage if improperly handled. Never touch the
lamps with your bare fingers as the oil from your
hands will shorten lamp life. Also, never move
the fixture until the lamps have had ample time
to cool. Remember, lamps are not covered under
warranty conditions.
Fuse Replacement: CAUTION! Never attempt to change the fuse
while the fixture is plugged in. ALWAYS disconnect the main power
before attempting to replace the fuse.
1. Loosen the small lock screw located on the front of the unit
2. After loosening the screw, remove the socket assembly cover.
3. Unscrew and remove the four phillips screws (A1, A2, A3, and
A4).
4. The fuse box is located on the PC board on the bottom left side,
pull the fuse box up to replace the fuse.
FUSE
A1 A2
A4
A3
Dynasty Scan DMX Fuse Replacement