Dixon Valve F1 Tool - Manual

BAND CLAMP TOOL
F1
Jack-type tool
For applying 5/8" width band clamps
Push tension handle all the way forward. Insert the
clamp tail and push all the way into tool.
Tighten the clamp with short downward strokes.
Tension handle should be in down position at
completion of tightening clamp.
If clamp tension needs to be released before lock-
ing, move slide back against spring. This raises the
pulling dog.
Holding tension handle down, lock clamp by hitting
punch at least twice with mallet.
1
2
3
Hold hose and raise the tool back and forth to
break off clamp tail. Remove from tool by operating
tension handle. when tail has moved through hold-
ing dog, raise tension handle and pull tail free.
4
Operating Instruction for the F1 Installation Tool