Dixon Valve C2 tool - Manual

BAND CLAMP TOOL
C2
Jack-type tool
Operating Instructions for the C2 Installation Tool
Pull strapping from carton and cut off. Slide clamp
on strap and bend end under at ear side of clamp.
Bring opposite end of strap around object twice,
each time passing under clamp bridge.
Raise ball handle to forward position and insert
strapping. Slide tool forward.
Slide cutter handle forward for alignment. Jack ball
handle to reach desired tension.
Retract cutter handle and raise to 90-110°. To cut
strapping, rotate cutter handle. Increase locking
bend by rotating tool forward. Apply thumb pressure
on tab as you remove tool. Bend ears with hammer.
1
2
3
4
For applying 3/8" and 5/8" width clamps