Dixon Valve 51960 tool User Manual
Screw-action type
Advertising
BAND CLAMP TOOL
Hold the tool in the left hand so that the cutter bail
is on the bottom and the pulling dog lever is on top.
Slide the strap tail through the slot on the right side
of the tool.
Press down on pulling-dog lever and rotate handle to
begin tightening. Tighten strap to desired tension.
Simultaneously relieve some tension while pushing
the tool away as far as possible.
Pull the cutter bail to cut the strap tail. Tap the
buckle ears down to hold the cut strap tail in place.
1
2
3
Operating Instructions for the 51960 Installation Tool
51960
Screw-action type
For installing band and buckle type clamps
Advertising