Acer AC701 - Manual (Page 3)

3
Important Safety Instructions
1. Please read these instructions thoroughly.
2. Please keep this guide for future use.
3. Please disconnect the device from the main power supply before cleaning. Do
not use any liquids or aerosol sprays to clean this device. Use a clean
dampened cloth in stead.
4. To avoid damaging the device, only use factory-approved accessories.
5. Protect the device against moisture.
6. In order to set up the device, first place it on a stable surface. Tipping it over or
dropping can harm the monitor and cause injuries. Please follow the setup
instructions of the manufacturer while setting up your monitor.
7. The ventilation openings are used for air circulation to protect the device
against overheating.
8. When connecting the device, obey the maximum connected load values of the
main power supply.
9. The wall socket must be equipped with a non-fused grounded conductor
contact for electrical safety.
10. The power cable must be laid in such a way nobody can trip over it. Please do
not place any objects on the cable.
11. Follow all instructions and warning remarks that are printed on the device.
12. If the device will not be used for a long period of time, please disconnect it
from the main power supply to avoid power surge damage such as lightning.
13. Make sure no sharp objects or liquids enter the device via its air circulation
openings. This could result in a fire or an electric shock.
14. Never open the device casing yourself, there are no user serviceable parts
inside. Only authorized technical service personnel should open the casing of
this device.
15. If any of the following conditions occur, the device must be disconnected from
the main supply, and be checked by a qualified service center:
a- Power cable or power plug are damaged;
b- Liquid has entered the device;
c- The device was exposed to moisture;
d- The device does not operate according to the user’s guide, or you do not
achieve any improvement with the aid of this guide;
e- The device has been dropped and/or the casing is damaged;