Nitek FRS2020 - Manual (Page 2)

Installation Instructions
Refer to the diagrams on the previous page and below for installation. Use best industry practices and follow all local
building codes. The chassis can be desktop or rack mounted.
1. For a rack-mount installation, use the appropriate screws to fix each side of bracket onto the rack.
2. Remove the two Hex Head screws on the front of the unit and pull the card unit out of the wall mount chassis.
3. Install the Receiver/Transmitter card (up to 16) by sliding in the card along the plastic card guides, making sure that
the card is properly is all the way in and properly inserted into the backplane connector.
4. Screw in the thumb/hex head screw on the top of the face plate to firmly secure the card in the unit.
5. Connect monitors and control panel to the video port and data port of each receiver card module respectively.
6. Connect PTZ cameras to the video port and data port of each transmitter.
7. Connect the supplied AC line cord to the 2 power supplies in the chassis and plug in the cords to the AC wall outlet
and turn on the 2 power supplies; connect the supplied power supply to the transmitter.
8. Connect, at the camera end, the supplied power supply to power the FTS20111S Transmitter.
Note there are no technical adjustment required during or after installation.
Rear View
Both power cords must be plugged-in
and both power supplies turned-on, in
order to benefit from the dual set-up.
Insert cards as shown, by
sliding the cards into the card
guides, use the supplied
mounting screw to secure the
card into the card rack.
Data In and Out are labeled
for connection type, i.e. Tx+
from transmitter goes to the
Tx+ of the camera.
Typical Hook-up