Nitek FTS324104R00 User Manual
Nitek, Installation manual, 2 camera transmitter w/data and aux comm
Installation Manual
FTS324104R00 Dual Transmitter
2 Camera Transmitter w/Data and Aux Comm.
Note: This installation should be made by a qualified
service person and conform with local codes.
Reduce risk of fire or electrical shock do
not expose this product to rain or moisture.
!
Specifications
Video Connection
Connector
75 ohm BNC Socket
Input Impedance
75 ohm terminated
Input Level
1 volt p-p nominal
Frequency Response
10Hz to 10MHz
Optical Connection
Connector
SC
Style
Path Loss
20 dB
Wavelength
1310
/
1550nm
Dimensions
Width
1
Card
slot
Power Connection
Provided from FSR1000 Card Rack
Auxiliary Ports
Data Selectable
RS422/RS485/RS232
Alarm
In
Contact
Closure
Alarm Out Relay
100V / 150mA max
NITEK
®
5410 Newport Drive, Suite 24
Rolling Meadows, IL 60008
PHONE (847) 259-8900
FAX (847) 259-1300
WWW.NITEK.NET
Installation Instructions
- The fiber transmitter is designed to be mounted in the FSR1000 Fiber Card Rack.
- Always allow for bend radius of optical and electrical cables when installed.
680600111 Rev 02102009
Service Information
There are no user serviceable parts inside the unit. In the event that service is required to this unit please
contact NITEK Technical Support at 800-528-4343.
CH
1
C
H2
NITEK
CH1
POWER
VIDEO/OPTO
CH2
DATA OUT
DATA IN
ALARM OUT
ALARM IN
CH1
CH2
OPTO IN / OUT
Color Description
Green
Data is Low / Logic 0
Red
Data is High / Logic 1 (RS422/485)
Off
Data is Tri-state / (High - RS232)
Data LED
Color Description
Green System
Normal
Yellow (RX) Link working, No video at TX
Red
(TX) Power on, No video into TX
(RX) Power on, No opto into RX
Power/Video/Opto LED
Data CH1
RS485
RS422
RS232
Data
RS485
RS422
RS232
IN + (A)
7
1
2
IN - (B)
8
2
--
OUT + (A)
7
7
8
OUT - (B)
8
8
--
GND
6
6
6
Rear Panel Data Connections
Set Data Format with Internal Switch
Alarm Connections
Alarm
Pin
OUT +
3
OUT -
4
IN +
5
GND
6