Nitek PS4816W - Manual

TOP VIEW
BACK VIEW RIGHT VIEW
1.25 1.25 4.50
7.00
1.00
6.12
8.00
LEFT VIEW
Model PS4816W
Installation and
Operation Manual
NITEK
®
De Schans 19-21 2a
8231 KA Lelystad
Tel: +31(0)320-230005
E-mail: [email protected]
WWW.NITEK.NL
USA
5410 Newport Drive, # 24
Rolling Meadows, IL 60008
Phone: (847) 259-8900
Fax: (847) 259-1300
E-mail: [email protected]
WWW.NITEK.NET
EUROPE
08232013
680240116
Note:
This installation should be made by a qualified
service person and conform with local codes.
Reduce risk of fire or electrical shock. Do
not expose this product to rain or moisture.
Introduction
The PS4816W is a wall mounted 16 output channel 48Vdc power source for various PoE and non-PoE devices. Wiring
is connected to the distribution board via easy to use screw terminals. The terminals are capable of supporting 16 AWG
wires, and have markings for polarity. The PS4816W can support the power needs of various cameras with power loads
of up to 240 Watts total output and individual outputs up to 30 Watts.
Wall Mounting Instructions
1. Mount the unit on a flat surface that provides room to run cable conduit to the box and be able to open the top cover.
2. There are four mounting holes provided, do not drill extra holes in the box, the drawing below is 1:3 scale.
3. There is provided five standard 1/2” Trade knockouts, actual opening diameter 7/8”, for routing AC and DC cabling
into the box.
Chassis
Mounting
Holes
1/2” Trade
Knockout
1/2” Trade
Knockout
1/2” Trade
Knockout