Control Company 5122 INSTANT-RECALL MEMORY TIMER - Manual

CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV
and ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 5122
Traceable® Instant-Recall
Memory Timer Instructions
92-5122-00
Rev. 0 051704
Traceable ® is a registered trademark of Control Company
© 2004 Control Company
TRACEABLE® INSTANT-RECALL MEMORY TIMER
INSTRUCTIONS
SPECIFICATIONS
Display: 3 / 4
² high 4-digit LCD
Timing capacity: 99 min, 59 sec
Resolution: 1 sec
Accuracy: 0.01%
Alarm: 30 sec audible
Size/Weight: 2 1 /
2
x 2 1 /
4
x 3 /
4
², 2 oz
CLEARING THE DISPLAY TO ZERO
Press MIN and SEC buttons simultaneously to clear the
display to zero. The display may be cleared to zero whether
or not the timer is running.
TO SET TIMER
• Press MIN, SEC buttons to set desired timing period. Press
and hold MIN or SEC button to rapidly advance display.
TO START TIMER
• Once desired timing period is shown on display, press
START/STOP button to start countdown (see Time-Out
section).
• When timer reaches zero, the alarm sounds for 30
seconds then automatically shuts off unless turned off
manually. Press any button to manually silence the alarm.
TIME-OUT
If a pause in the timing operation is required, press the
START/STOP button to “freeze” the display at the current
reading (time-out). To resume timing at the point it was
stopped, press the START/STOP button again. Any
number of time-outs may be performed.
BUILT-IN MEMORY FUNCTION
Pressing the START/STOP button to silence a
sounding alarm also returns the display to the
previously programmed time. Only the START/STOP
button returns the display to the previously set time.
ALL OPERATIONAL DIFFICULTIES
If this timer does not function properly for any reason,
please replace the battery with a new high quality
battery (see Battery Replacement section). Low
battery power can occasionally cause any number of
“apparent” operational difficulties. Replacing the
battery with a new fresh battery will solve most
difficulties.
BATTERY REPLACEMENT
A faint display, incorrect display, erratic display, or no
display are all indicators that the battery must be
replaced. On back of unit, slide off the battery cover.
Remove the exhausted battery and replace with a new
AAA alkaline battery. For proper placement, see
drawing located inside battery compartment. Replace
battery cover. Replacement battery: Control No. 1105.
WARRANTY, SERVICE OR RECALIBRATION
For warranty, service or recalibration contact :