Control Company 5060 24-HOUR DIAL CONTROLLER/7-DAY DIAL CONTROLLER - Manual

©2007 Control Company. 92-5060-00
SWITCHING CAPACITY
125 VAC, 15 AMP, 1875 Watts Resistive
120 VAC, 1/3 Horsepower
125 VAC, 10 AMPS, 1250 Watts Tungsten
OPERATION
1. With your finger, pen, or small screwdriver, press down the pins corresponding to the required “ON” time.
Make certain that pin for the “ON” time is depressed completely (you should be able to see the orange “ON” indicating
color behind the pin).
Note: Each pin on the 7-Day Controller represents 2 hours. Each pin on the 24-Hour Controller represents 15 minutes.
2. Turn the outside dial clockwise until the present time aligns with the pointer at the top right corner.
3. Plug the outlet controller into an outlet and plug the equipment to be controlled into the controller (make certain that
equipment to be controlled is turned ON).
MANUAL SWITCHING
On the upper right side of the controller is a manual switch for turning your equipment on without disturbing your program
settings. With the manual switch set to ON, the controller will continuously power the equipment being controlled until it is
set to AUTO. Once set to AUTO, the controller will resume the programmed switchings.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025
accredited as a Calibration Laboratory by A2LA.
© 2007 CONTROL COMPANY
24-HOUR DIAL CONTROLLER/7-DAY DIAL CONTROLLER INSTRUCTIONS