Control Company 5036 WATER-RESISTANT/FLASHING TIMER - Manual

CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV
and ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 5036
Traceable ® Water-Resistant Flashing Timer Instructions
92-5036-00
Rev. 1 062504
Traceable® is a registered trademark of Control Company
© 2004 Control Company
TRACEABLE® WATER-RESISTANT, FLASHING TIMER INSTRUCTIONS
SPECIFICATIONS:
Display: ½”
LCD
Range: 99 Minutes, 59 seconds to zero
Resolution: 1 second
Accuracy: 0.01%
Alarm: 1
Minute audible alarm, bright red LED flashing visual alarm
Function: Countdown timing
Features: Water-resistant, Audible alarm, Flashing red LED when time is up, Infinite timeouts,
Supplied with lanyard and suction cup.
CONTROLS/INDICATORS
Separate START and STOP buttons, and ten time-setting buttons, numbered “1” through “10”.
OPERATION
1. Select desired countdown time with buttons “1” through ”10”.
2. Press the “START” button to begin countdown.
3. Press the “STOP” button for timeouts or to stop the countdown.
4. When zero is reached a bright red LED flashes and an audible alarm sounds for one minute.
5. Alarm can be turned off by pressing any of the buttons on the unit.
6. To clear the time entry, press the “STOP” button twice.
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any reason, replace the battery with a new high-quality battery (see “Battery Replacement”
section). Low battery power can occasionally cause any number of “apparent” operational difficulties. Replacing the battery with a new
fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display or no display are all indicators that the batteries must be replaced. The two battery compartments
located on the back of the unit can be opened with a screw driver (turn in the direction indicated). Replace exhausted batteries with
two new 1.5 volt batteries. When replacing battery compartment covers, carefully ensure that each cover is properly in place in order
to maintain the unit’s water-resistance. Replacement Battery Cat. No. 1039.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact: