Control Company 5026 QC TIMER User Manual
Control company
SPECIFICATIONS
Display:
¾’’ LCD
Range:
Counts down from 20 hrs.
Resolution:
1 min.
Accuracy:
0.01%
Case:
ABS plastic
Power:
One 3-year AAA battery
Accessories Supplied:
3-year AAA battery, magnet/clip, Traceable
®
certificate, instructions
QC Timer Operation
1.
Turn the timer on by inserting the battery. To insert the battery, slide the battery cover located on the back of the unit away from the unit. Place the supplied
battery inside. Replace the battery cover.
2.
To set the desired time, press the HR and MIN buttons. Each press advances the time 1 hour or 1 minute, respectively. To rapidly advance the time, press and
hold the buttons.
3.
Press the START/STOP button once to begin counting down. The blinking colon (:) indicates the time is running.
4.
To temporarily stop the countdown time, press the START/STOP button once. To resume countdown, press the START/STOP button again.
5.
When the timer reaches zero, an alarm will sound for 1 minute. Press the ALARM STOP button to silence the sounding alarm.
6.
When the timer is counting down, clear the display by pressing the START/STOP button to stop the countdown. Then press the CLEAR button. If the timer is
not counting down, press the START/STOP button twice and then press CLEAR.
Battery Information
Please replace the battery in the case of any operational difficulties or lack of proper functionality for any reason. Slide the battery cover located on the back of the
unit away from the unit. Remove the old battery and replace it with a new AAA battery. Replace the battery cover. Incorrectly installed batteries may damage
electronics.
Replacing the battery with a new fresh battery will solve most difficulties.
Warranty, Service, or Recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration
Laboratory by A2LA.
Control Company Cat. No. 5026. Rev 1 040808
Traceable
®
is a registered trademark of Control Company
© 2008 Control Company
TRACEABLE
®
QC TIMER INSTRUCTIONS