Accton Technology ES3526XA - Manual (Page 292)

Command Line Interface
4-50
4
Example
The following example shows sample messages stored in RAM.
SMTP Alert Commands
These commands configure SMTP event handling, and forwarding of alert
messages to the specified SMTP servers and email recipients.
logging sendmail host
This command specifies SMTP servers that will be sent alert messages. Use the no
form to remove an SMTP server.
Syntax
[no] logging sendmail host ip_address
ip_address - IP address of an SMTP server that will be sent alert
messages for event handling.
Default Setting
None
Console#show log ram
[5] 00:01:06 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[4] 00:01:00 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[3] 00:00:54 2001-01-01
"STA root change notification."
level: 6, module: 6, function: 1, and event no.: 1
[2] 00:00:50 2001-01-01
"STA topology change notification."
level: 6, module: 6, function: 1, and event no.: 1
[1] 00:00:48 2001-01-01
"VLAN 1 link-up notification."
level: 6, module: 6, function: 1, and event no.: 1
Console#
Table 4-21 SMTP Alert Commands
Command Function Mode Page
logging sendmail host SMTP servers to receive alert messages GC 4-50
logging sendmail level Severity threshold used to trigger alert messages GC 4-51
logging sendmail
source-email
Email address used for “From” field of alert messages GC 4-52
logging sendmail
destination-email
Email recipients of alert messages GC 4-52
logging sendmail Enables SMTP event handling GC 4-53
show logging sendmail Displays SMTP event handler settings NE, PE 4-53