Control Company 4144 STICK THERMOMETER - Manual

Traceable ® is a registered trademark of Control Company ©2011 Control Company. 92-4144-00 Rev. 3 050911
INSTALLATION INSTRUCTIONS
1) Probe sensor: Place the submersible probe inside the tank
and press the suction cup against the inner wall. Choose a
position which is less affected by light or plant for more
reliable readout.
2) Unit: Remove the protective paper of the double-sided tape
and press the unit against any clean surface for mounting.
OPERATING INSTRUCTIONS
1) Temperature readouts will display after battery is inserted.
2) Press MAX-MIN MEMORY button will display maximum and
minimum, readouts of room temperature. Second press will
display maximum and minimum readouts of water
temperature. Third press, or after 8 seconds the display will
show current temperature readout.
3) If you press CLEAR after maximum or minimum temperature
readout is recalled from the record, you will start a new
memory record and the old one is erased.
Maximum/Minimum temperature is the Highest/Lowest
temperature readout as picked up from the accumulated
temperature readouts. Thus you can specify, HOURLY,
DAILY, WEEKLY, MONTHLY Room/Water max-min
memory record by yourself.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025
accredited as a Calibration Laboratory by A2LA.
TRACEABLE ® STICK™ THERMOMETER INSTRUCTIONS