Control Company 4122 SOLAR-POWERED THERMOMETER - Manual

Traceable ® is a registered trademark of Control Company ©2008 Control Company. 92-4122-00 Rev. 3 051908
SPECIFICATIONS
Display:
½” high 4-Digit LCD
Range: 23.0 to 122.0°F (–5.0 to 50.00 C)
Resolution: 0.1 degree
Accuracy: ±1°C
THERMOMETER
To activate the battery, remove the insulating tape from the battery
compartment. The battery is used to supply power to the unit during
low light conditions.
DISPLAYING °F OR °C
Remove the plastic panel located below the solar
panels by using a blunt tipped tool (See Fig. 1).
Slide the °C/°F switch to °C to display the
temperature in Celsius or to °F to display the
temperature in Fahrenheit (See Fig. 2). Replace the
plastic panel.
WALL MOUNTING
Removable— The unit is provided with a screw for removable wall
mounting. Set the screw into the wall at the location desired, the
head of the screw will need to slip into the receptacle on the back of
the unit, so do not set the screw flush to the wall. Once the screw has
been properly set, hang the unit in place by sliding the receptacle on
the back of the unit over the head of the screw. The unit may also be
mounted to any clean, smooth surface by using the supplied Velcro
strips.
Permanent— Two mounting holes are provided for
permanent wall mounting. To permanently mount
the unit to the wall, remove the plastic panel below
the solar panels by using a blunt tipped tool (See
Fig. 1). Hold the unit on the wall at the location
desired and set two screws in the mounting holes located on either
side to the °C/°F switch (See Fig. 2). Tighten the screws securely
and replace the plastic panel.
DISPLAY MESSAGES
MIN or MAX appearing on the display or HHH flashing on the display
indicates that the unit is in a power lock-up mode and that the unit
must be reset. To reset the unit and clear the message from the
display, remove the plastic panel located below the solar panels by
using a blunt tipped tool (See Fig. 1). Press the Reset button located
to the left of the °C/°F switch (See Fig. 2). Replace the plastic panel.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, please
replace the battery with a new high quality battery (see “Battery
Replacement” section). Low battery power can occasionally cause
any number of “apparent” operational difficulties. Replacing the
battery with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
A faint display, no display, erratic readings, or operational difficulties
indicate that the battery should be replaced. Remove the battery
cover, located on the back of the unit, by turning it ⅛ of a turn
counter-clockwise. Replace the battery with a new 1.5V, G-1 3
battery. Equivalent battery replacements are: RAYOVAC RW42,
DURACELL D357, and EVEREADY 357. Insert the battery with the
positive side facing you. Replace the battery cover.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-
Certified by DNV and ISO 17025 accredited
as a Calibration Laboratory by A2LA.
TRACEABLE ® SOLAR-POWERED THERMOMETER INSTRUCTIONS