Control Company 4149 ROBO THERMOMETER - Manual

CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281-482-1714 Fax 281-482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 4149/4349
Traceable ® Robo™ Thermometer Instructions
92-4149-00
Rev. 3 083006
Traceable ® is a registered trademark of Control Company © 2006 CONTROL COMPANY
TRACEABLE ® ROBO ™ THERMOMETER INSTRUCTIONS
SPECIFICATIONS:
Display: ¼” LCD
Range: –58.0 to 536.0 °F
–50.0 to 280.0 °C
Resolution: 0.1° above –20.0° and below 200.0°
1.0° below –20.0° and above 200.0°
Accuracy: Cat. No. 4149
±1°C –20 to 100 °C
Cat. No. 4349
±0.4°C –20.0 to 100.0 °C at
tested points
Sampling
Rate:
1 second
Features: Protective sleeve with pocket clip,
8” stainless steel probe, 180 de-
gree rotating digital display, extra-
wide temperature range.
CONTROLS/INDICATORS
°F/°C button and ON/OFF button.
ULTRA™ THERMOMETER ACCURACY
Ultra™ thermometers are tested at selected test
points to be within tighter than normal toler-
ances to assist in providing improved accuracy.
Other points will not necessarily fall within the
same accuracy as those found at the selected
test points, but will be within an accuracy of ±1°
between –20.0 and 100.0°C.
OPERATION
1. Press the “ON/OFF” button to turn the thermom-
eter on.
2. Press the “°F/°C” button to toggle between dis-
playing the temperature in Fahrenheit and
in Celsius.
3. Remove the thermometer from the protective
plastic sleeve and insert the probe into the mate-
rial to be measured.
4. The head of the thermometer rotates 180 degrees
in order to read the display at various angles.
5. Press the ON/OFF button to turn the unit off.
ALL OPERATIONAL DIFFICULTIES
If this unit does not function properly for any reason,
replace the battery with a new high-quality battery
(see “Battery Replacement” section). Low battery
power can occasionally cause any number of “ap-
parent” operational difficulties. Replacing the battery
with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display are
all indicators that the battery must be replaced.
Remove the battery cap by turning ¼ turn counter
clockwise. Replace exhausted battery with a new
1.5 volt battery. Make certain that positive (+) side
is face up. Replace battery cap. Do not overtighten
the cap. Replacement battery Cat. No. 1039.
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact: