Amplifier Tech AT2000 - Manual (Page 4)

Page 4
Getting to Know the Rear Panel
A XLR Balanced Audio Inputs
Use the BALANCED INPUT jacks to connect to the outputs
of a preamplifier or other control device with XLR outputs.
B Unbalanced Audio Inputs
Use the UNBALANCED INPUT jacks to connect to the ouputs
of a preamplifier, receiver with preout connections,
CD player, or other control devices.
C Remote Trigger Input
Use the REMOTE TRIGGER jack to connect to a compatible
preamplifier, source device, or other product with a
3.3-24VDC output.
D Product Serial Number
Write this number in the space provided on page 10 for
future reference.
D Speaker Outputs
Use the OUTPUT binding posts to connect the amplifier to
your speakers; red for positive, black for negative.
E AC Input
Use the included power cord to connect your amplifier to
an AC power source.
F Master Power Switch
Turns the current to the amplifier on or off.
NOTE: The picture below is an AT2007 seven-channel model.
It differs from the AT3007 only in the extra space on the panel.
Other models ranging from two to six channels will only
have two to six sets of balanced audio inputs, unbalanced audio
inputs and speaker outputs.
Connecting Your Amplifier
When making connections between any source components
and the amplifier, or when making connections to any speaker,
be certain that both the input devices and the amplifier are
turned off. To assure that there will be no unwanted signal
transients that can damage equipment or speakers, it is always
best to unplug all equipment before making any connections.
B
E F G D
C A