Pach and Company AHP5 - Manual

Specifications: 12 VAC/12VDC 10 Watts
55.4 • F
Installation (Factory Pre-installed)
Step 1: Turn the system power OFF.
Step 2: Connect the AHP5 as shown below, polarity not important.
Step 3: Turn the power On.
Installation (Factory NOT Pre-Installed)
Step 1: Turn the system OFF.
Step 2: Install the heater pad behind the LCD screen. Provide 1/4” clearance from the back of the LCD.
Warning: Do not install the heater pad on top of the LCD without a clearance, It may damage the LCD.
Step 3: Install duct tape on the LCD’s ribbon cable.
Step 4: Connect the AHP5 as shown below, polarity not important. You may use the same power transfomer as the
AeGIS Telephone Entry System.
Step 5: Turn the power On.
CHECK THE FOLLOWING AFTER TURNING ON THE HEATER PAD
a. INPUT VOLTAGE MUST BE 12.5VAC-13.5VAC UNDER LOAD IF 12VAC 40VA TRANSFORMER IS
USED.
b. INPUT VOLTAGE MUST BE 13.6VDC-14.5VDC UNDER LOAD IF 12VDC 3.0A TRANSFORMER IS
USED.
Separate power must be used if the voltage is low.
AeGIS Heater Pad (AHP5) AeGIS Heater Pad (AHP5)
Inst Inst allation and S allation and S pecifications pecifications
12VAC 1A or 12VDC 1A