PASCO DataStudio Installation - Manual (Page 26)

012-08936
DataStudio 1.9.0 Installation Instructions
26
Installing DataStudio for PASPORT on Mac OS X
PASCO Technical Support tel: (800) 772-8700 / (916) 786-3800
email: [email protected]
web: http://www.pasco.com/support/
2. Connect the PowerLink (without any sensors) to one of the computer’s USB ports with
the provided USB cable.
• If this PowerLink’s firmware is current, nothing will happen. Continue to step 3
below.
• If this PowerLink’s firmware is old, DataStudio will inform you. Choose Yes twice
to proceed with the upgrade.
3. Once this PowerLink’s firmware is current, disconnect it and repeat this process for every
PowerLink you would like to upgrade.
4. Disconnect any PASPORT interfaces from the computer and close DataStudio.
4. Verification
key point
• Verify that the installation process has succeeded by briefly collecting sensor
data using a teacher or student login.
Verify that the installation has been successful.
1. Log out your administrator account and log back in using the same account type as your
teachers or students.
2. Plug a USB Link, Xplorer, or PowerLink into one of the computer’s USB ports.
3. Connect a PASPORT sensor (such as the Temperature Sensor) to the USB Link, Xplorer, or
PowerLink.
4. The PASPortal monitor, which is automatically running in the background, should detect the
sensor and open the PASPortal window. Choose Launch DataStudio.