Audiovox HOME BASE DPF711K - Manual (Page 8)

8
INSTALLATION (cont’d)
Countertop Installation
1. Find a suitable location on the countertop near an AC wall outlet.
2. Connect the power adapter plug to the DC input connector at the rear of the homebase.
3. Determine how best to route the power adapter wire in reference to the AC wall outlet – to the left
or right side of the homebase – and slip the DC wire into the corresponding wire notch on the back
of the unit.
4. Check the amount of wire required to reach the AC outlet; spool any excess wire onto the four posts
inside the rear hollow of the homebase.
5. Attach each angle mount bracket to the homebase by lining up the individual angle mount bracket
upper mounting tab with its corresponding hole on the homebase.
6. Push each angle mount bracket towards the top of the homebase until the upper mounting tab
engages the mounting hole slot; when the bottom of the angle bracket contacts the homebase, the
tab on the bottom of the angle bracket snaps into place.
7. Place the homebase in the desired location.
DPF711K
DC Input Connector
Power Adapter
Wire Notches
Angle Bracket Mounting Holes
Wire Post(s)
Angle Mount
Brackets
homebase
Unit
Bracket Upper
Mounting Tabs
Bracket Lower
Mounting Tabs
HB-711-OM-128-8270-Eng.qxp 6/5/08 9:37 AM Page 8