Alen T300 - Manual (Page 9)

10 Helping People Live Better
6. Place the UV light holder back over the UV light and secure the screw for the wire harness.
7. Re-secure the cover for the UV light compartment.
8. Used UV bulbs are recyclable.
Maintenance notes:
1. Always unplug the unit when installing a filter or replacing the UV light.
2. Distinguish the front side from the back side of the filter.
3. It is recommended to wear gloves while discarding the used UV bulb and filters. Place the
used filter in a plastic bag to prevent dust from reentering the air. The UV bulb is recyclable.
TRoUbLEShooTiNg TiPS
How do I reset the filter indicator lights? I put in a new filter but the bars are
still illuminated.
After changing the filter, RESET the filter indicator by holding down RESET while the unit is ON
until the illuminated bars disappear. To reach the button, use a pin or extended paperclip.
How do I find out what electric specifications my unit needs?
Please refer to the rating label on the side of the unit. Here you will find your units voltage, hertz,
amp and outlet requirements.
Can I clean the filter?
The black foam layer of the filter, known as the Pre-Filter, captures large dust and hair. This layer
is held on with Velcro®. Once removed, the Pre-Filter can be washed or vacuumed to maintain
efficient operation of the unit. No other layers or parts of the filter can be washed, cleaned or
otherwise reused. Please replace the filter regularly to maintain optimal
performance.
The blue light at the bottom of my unit is blinking.
This indicates that the UV light will soon burn out. Call 1-800-630-2396 to order a replacement
UV light. UV lights are like normal light bulbs and will last approximately nine to twelve months
when operated continuously.
I have an issue not listed in this manual.
Please visit www.AlenCorp.com and send us a message or call 1-800-630-2396. A customer ser-
vice representative will respond to your inquiry in a timely manner, in most cases within a couple
of hours.