PERKO 1111 - Manual

16490 N.W. 13th Avenue Miami, FL 33169-5707
Scale: None
Date: 11/3/82
Revised: 9/12/01
Drawn By: D. Beutler
FIG. 1111ME1GAL AND FIG. 1111ME1PLB
SPECIAL YELLOW FLASHING LIGHT
Bill of Material
NOTES:
1. Lens
- Yellow, American Made Fresnel
225° PERKO Cat. No. 0256001YLW
2. Socket - Medium Prefocus Phenolic, 250 Volts,
1000 Watts Bryant No. 3743, UL Listed
(Cat. No. 0347A00)
3. Weight - 6-5/8 Pounds
Cat. No. Description Visible Visible Reg. Lamp
Arc Miles Watts Cat. No.
1111ME1GAL Special
225° 2 60 0342004CLR
1111ME1PLB Yellow Flashing
VISIBILITY AND WATTAGE SPECIFICATIONS*
*BULB DATA - THESE ARE SPECIAL PERKO NAVIGATION
LAMPS, 120 VOLTS, T-10, MEDIUM PREFOCUS
BASE, C-8 FILAMENT, CLEAR 2-3/8 INCH L.C.L.,
AND MUST BE USED TO MEET THE U.S. COAST
GUARD REQUIREMENTS.
No. Name of Piece No. Req. Material Size & Spec.
1 Cap & Cable 1 Polycarb. Cat.No. 1105000BLK
2 O-Ring Fig. No. 1119 1 Neoprene 4-5/8” x 4-1/4” x 1/8”
3 Lens 1 Polycarb. See Note #1
4 Socket 1 See Note #2
5 Socket Support Stand 1 Brass Fig.No. 0341001PLB
6 Socket, Mounting Screws 2 Brass 8-32 x 3/8” R.H.
7 Body 1 Brass or 20 GA-.032
Galv. Steel
8 Electronic Flasher 1 120 Volts AC Only
Cat. No. 0133 Rate: 60 Flashes per Minute
9 Packing Gland 1 Plastic for 7/16” Cable
11 Ground Screw & Nut 1 Brass 8-32 x 3/8” R.H.
WIRING DIAGRAM FOR
SPECIAL FLASHING YELLOW LIGHT
This light is designed to meet Federal Requirements under
the U.S. Inland Navigation Rules Act of 1980, requiring a
flashing yellow 180° - 225° light. See applicable Inland Rules
for technical details.
WIRING INSTRUCTIONS
1. Flasher Module is designed to operate on 120 volt ± 15%
A.C. system only.
2. Required lamp for compliance to the two mile visibility
requirement is PERKO Cat. No. 0342004CLR (60 Watt -
120 Volt).
3. Flasher Module must be wired in series with the lamp as
illustrated.
4. Actual wiring must be accomplished by a qualified
marine electrician to all applicable codes and regulations.