PERKO 0318 - Manual

0318INS1
Cat. No. 0318A00 Dual Voltage Interior Light
Cat. No. 0318DP Dual Voltage Interior Light
INSTALLATION INSTRUCTIONS
The Cat. No. 0318A00 dual voltage interior light is equipped with two 12 volt bulbs (ANSI #1004, PERKO Cat. No.0 337012CLR), two 120
volt bulbs (G.E. #15T7, PERKO Cat. No. 0337023CLR) and two separate switches marked “High” for 120 volt use and “Low” for 12 volt
use.
THIS INSTALLATION MUST BE PERFORMED BY A QUALIFIED MARINE ELECTRICIAN.
READ ALL INSTRUCTIONS BEFORE PROCEEDING:
1). CAUTION! Insure current is de-energized before beginning installation. Light fixture should be wired in accordance with N.F.P.A.
Standard #302*, A.B.Y.C. Safety Standards E-8 and E-9 (A.C. and D.C. Electrical Systems on Boats), and U.S.C.G. Safety
Standard for Boat Electrical Systems (33 CFR 183)*. This unit is not ignition protected.
2). Remove retaining screw and lens.
3). Open junction box by removing the two screws on opposite corners.
4). Remove “knockout” for 120 volt service by tapping from back side of light.
5). Align fixture on mounting surface such that both conduit connection and 12 volt wire grommet are properly located. While
holding fixture in desired location, mark for mounting #10 screws in the center of the small part of each keyhole slot.
6). Install mounting fasteners, leaving room under the heads to position and shift fixture.
7). While holding fixture near to mounting surface, lead 12 volt wires through the grommet and 120 volt wires through the
“knockout”.
8). Place fixture in desired position on mounting surface and tighten fasteners. Secure conduit through “knockout”.
9). Make electrical connections as follows:
A). Attach 12 volt negative supply lead to pair of twisted wires marked “Low 12 volt”.
B). Attach 12 volt positive supply lead to single free lead from switch marked “Low 12 volt”.
C). Attach 120 volt neutral supply lead to pair of twisted wires marked “High 120 volt”.
D). Attach 120 volt hot supply lead to single free lead from switch marked “High 120 volt”.
E). Make certain to make a proper ground to fixture frame by connecting a ground wire to fixture grounding screw.
10). Replace junction box cover noting triangular tab on corner of cover which allows only one orientation.
11). Replace globe, noting notch at bottom edge on one end of globe must align with tab on mounting flange of fixture.
* The above referenced standards can be obtained from:
1). American Boat & Yacht Council, Inc. 2. U.S. Coast Guard
3069 Solomon’s Island Road Washington, D.C. 20593
Edgewater, Maryland 21037 (or your local C.G. office)
3). National Fire Protection Association
470 Atlantic Avenue
Boston, MA 02210
PERKO, INC.
16490 N.W. 13th Avenue
Miami, FL 33169-5707
www.perko.com
9/05