Perma Pure Mini-GASS 2812T - Manual (Page 10)

10 Mini-GASS User Manual
Figure 4
3. Installation
(Refer to Figure 4 for reference)
3.1 Mounting
Unit should be shielded from direct rain and snow. Do not install outdoors if
temperature will fall below -10°C.
Probe - refer to Appendix D
Automatic Blowback -refer to Appendix D
Z-Purge - refer to Appendix F
General flow schematic - refer to Figure 4
1. Install Mini-GASS system on vertical surface with dryer/filter compartment on top
and control compartment on bottom.
2. Place mounting feet on each corner of enclosure with slotted end protruding at
45 degree angle from enclosure.
3. Drop mounting screw in from top and tighten into foot.