Perma Pure Baldwin-Series M225 User Manual
Page 9
Advertising
Section E: Start-up Procedure
9
E:
S
TART
-
UP
P
ROCEDURE
Plug in the power cord to a properly grounded main circuit. The Ready Green LED
will come on within 3 minutes, indicating the relay temperature (10°C) has been
achieved. After approximately 3 minutes, the set point of +5°C. (41°F) is achieved.
The sample gas flow may be started immediately after the READY Green LED
comes on.
The Model M225 is virtually maintenance free. However, in the event of electrical
problems, refer to the troubleshooting guide in this manual. All voltages can be read
at the PCB terminal strip. Any deviations from the correct voltages indicate a
problem.
Advertising