Alliance Laundry Systems 105 - Manual (Page 54)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
52 M414545
COIN-OPERATED TUMBLER
1. Energize the electrical circuit to the tumbler at the
disconnect switch or the circuit breaker.
2. Open the lint screen panel and check for any
accumulated lint on lint screen. Close panel tightly
against tumbler frame and lock panel securely.
3. Open the loading door and load the cylinder with
laundry. Overloading will result in excessive drying
time, wrinkled laundry, and wear to cylinder
bearings.
4. Set the TEMPERATURE selector at HIGH (190ºF /
87.5ºC), MEDIUM (162ºF / 72ºC), LOW (140ºF /
60ºC), or anywhere between these settings. The type
of fabric being dried will determine the setting.
5. Coin Drop Models
Insert the required number of coins in the coin slot,
turn the knob to the right and release it.
Coin Slide Models
Insert the required number of coins in the coin slide,
push coin slide mechanism in completely and then
release it.
Electronic Control Models
Refer to Electronic Control Supplemental manual
provided with tumbler.
IMPORTANT: If the loading door is opened during
the cycle, the heating system will shut off and the
motor will stop. However, the timer will continue to
run. To restart the cycle, the door must be closed and
the PUSH-TO-START button must be pressed in and
held for approximately three seconds.
6. When the cycle is completed, open door and remove
the laundry.