Perrycraft LPS Bed Rails - Manual

INLPS 90320
LPS Slotted Bed Rails
Installation Instructions
Caution: During the manufacturing process we make every effort to eliminate sharp edges and/or burrs on the
rail materials. However, sharp edges and/or burrs may exist; use caution when handling these materials.
Trucks with Stake-Pockets:
1. Position rails on truck bed in such a manner as to cover
the stake-pockets. Mark rails at the center of each pocket.
2. Drill a 5/16” dia. hole thru the bottom leg of rails at each
marked pocket location.
3. Insert 5/16” x 2.5” bolts through the rails and start the
toggle wing-nuts on to the bolts only far enough to insure
they will hold in position when end of the bolt is placed
into the stake-pocket hole(s).
4. Reposition rails on truck bed, pushing toggles into the
stake-pocket holes far enough for the toggles to properly
engage the inside walls of the pocket(s).
5. Make sure rails are in the desired position and tighten
all bolts securely.
Note: most trucks requiring the LPS76A rails will have only
four stake-pockets; the 76A units include an optional ¼” bolt
and mating lock nuts to secure the center of the rails if
desired. Drill ¼” hole thru rails and truck bed at the desired
location, and install the indicated ¼” bolts.
Trucks without Stake-Pockets:
1. Position rails on truck bed in the desired position, and
mark the position for drilling holes for the mounting bolts
in the desired location(s) along the rails.
2. Remove rails and drill ¼” holes as marked. Reposition
rails on truck and mark the location of the mounting holes
on the truck bed. Remove rails and drill holes in bed as
marked. Remove all drilling residue.
3. Place rails on truck bed and secure with ¼” bolts and
mating lock nuts.
Note: If installing rails on a truck having an over-the-lip type
bed liner and no stake pockets, rails must be secured using
self-tapping type fasteners (not supplied); minimum recommended
size is 3/16” x 1” stainless steel, self-tapping fastener.