Bosch TASSIMO T12 TAS1204 - Manual (Page 13)

11 11 en
Troubleshooting
H
Problem Cause Solution
The quality of the crema
has deteriorated. The beverage outlet is sticky
or dirty. Clean the beverage outlet. Please refer here
to the section e Cleaning.
Clean the brewing unit with the yellow
Service T DISC. Please refer here to the
section e Cleaning.
Build-up of limescale in the
appliance. Descale the appliance. Please refer here to
the section f Descaling.
Water is dripping from
the brewing unit. The T DISC is damaged or
leaky.
The T DISC has not been
pierced correctly. Do not use T DISCs that are damaged.
Only use each T DISC once.
Wait until the brewing stage has come to
an end and the appliance has cooled down.
Remove the T DISC and clean the brewing
unit. Please refer here to the section
e
Cleaning.
The piercing unit has not
been inserted correctly. Press the piercing unit into its holder using
both thumbs (until an audible click is
heard).
Water is collecting on
the surface below the
cup stand. This is condensation. Condensation may appear and is not
caused by any fault with the appliance.
Wipe the water away with a cloth.
The yellow Service
T DISC is damaged or
lost. The yellow Service T DISC can be
requested from Bosch Customer Services
(item no. 624088, contact information
included at the end of these instructions).
The beverage quantity
does not meet your
requirements. The T DISC bar code sends
volume information to the
appliance appropriate for
the beverage selected.
However, this information
can be individually adapted
to personal requirements. Reduced quantity:
During the brewing process, press the
Start / Stop button to interrupt this stage.
Increased quantity:
Press and hold the Start / Stop button until
the required beverage quantity has been
reached.
Build-up of limescale in
the appliance could cause
reduced quantity. Descale the appliance. Please refer here to
the section f Descaling.
TAS12xx_1Text_EU.indb 11 19.03.2013 14:52:24