Airlink APSUSB201W - Manual (Page 8)

Verifying Network Connection
Step 1 Click on Start, Run.
Step 2 For Windows 95/98/ME type command and click OK. For Windows 2000/XP, type cmd and
click OK.
Step 3 At the command prompt, type ping and the IP Address of the print server and press Enter.
For example, if you have changed the IP Address of the print server to 192.168.0.254, type
ping 192.168.0.254
If you kept the factory default IP address, type ping 192.168.1.254
Section 5
You should get four Reply from messages back from the print server similar to the following picture.
If you get Request timed out or Destination host unreachable message, please double-check your
network cable connection and try again.
If you still do not get any Reply from messages, use a paper clip and hold in the Reset button at the back
of the print server for ten seconds while it is turned on.
Note: Resetting the print server with the Reset button will reset the print server’s IP address to the factory
default. If you need to change the IP address of the print server again, use the PS Utility. After you have
changed the print server’s IP address, try to ping the print server again.
Step 4 Once you have received the four Reply from messages, you can proceed to the next section.