Bosch Dampfbügeleisen Sensixxx DA50 ProEnergy TDA502412E weiß grün - Manual (Page 17)

15
BOSCH
* Model dependent
EN
gl
ISH
3. Operate the iron in a vertical position at a
distance of 10 cm / 4 in, and press the shot of
steam button (2) repeatedly with pauses of
at least 5 seconds.
6. Ironing without steam

See the leaflet sides
This enables the iron to be used for dry
ironing.
Set steam regulator (3) to the position.
DripStop
7. Drip protection *

See the leaflet sides
lf the temperature is set too low, the steam is
automatically switched off to avoid dripping.
There may be an audible click when this occurs.
8. Spray

See the leaflet sides
This can be used to remove stubborn
wrinkles.
Do not use the spray function with silk.
secure
9. “secure” auto shut-off
function *

See the leaflet sides
The “secure” auto shut-off function switches
off the iron when it is left unattended, thus
increasing security and saving energy.
After plugging in the appliance, this function will
be inactive for the first two minutes in order to
give the appliance time to reach the set
temperature.
After such time, if the iron is not moved for 8
minutes while in the upright position or 30
seconds while resting on its soleplate (7) or on
its side, then the safety circuit will switch the
appliance off automatically and the indicator
lamp (15 *) will start flashing.
To reconnect the iron, just move it about gently.
10. after ironing

See the leaflet sides
1. Switch the steam regulator (3) from to “max”
and back again several times (self- cleaning).
2. Empty the tank. Hold the iron with the point
down and shake lightly.
3. Store standing on the rear, not on the base.
4. Do not wrap the power cord (14) too tight!
Tips to help you save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
1. Start by ironing the fabrics that require
the lowest ironing temperature. Check the
recommended ironing temperature in the label
on the garment.
2. Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
3 Only use steam if necessary. If possible, use
the spray function instead.
Try to iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the
iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the ‘iron dry’
program.
4. If the fabrics are damp enough, turn off the
steam regulator (3) completely.
5. Stand the iron upright during pauses. Resting
it horizontally with the steam regulator on
generates wasted steam.
Cleaning & maintenance

See the leaflet sides
E attention! risk of burns!
always unplug the appliance from the
mains supply before carrying out any
cleaning or maintenance operation on it.
1. If the iron is only slightly soiled, pull out the
plug and allow the soleplate (7) to cool down.
Wipe the housing and the soleplate with a
damp cotton cloth only.