Avaya SM61 - Manual (Page 8)

MJH; Reviewed:
SPOC 8/4/2011 Solution & Interoperability Test Lab Application Notes
©2011 Avaya Inc. All Rights Reserved.
8 of 47
Sagemcom_SM61
Step Description
3. Codecs
IP codec set 1 was used during compliance testing. Multiple codecs can be listed in
priority order to allow the codec used by a specific call to be negotiated during call
establishment. The example below shows the values used during compliance testing.
display ip-codec-set 1 Page 1 of 2
IP Codec Set
Codec Set: 1
Audio Silence Frames Packet
Codec Suppression Per Pkt Size(ms)
1: G.711MU n 2 20
2:
On Page 2, set the FAX Mode field to t.38-standard. The Modem Mode field should
be set to off.
Leave the FAX Redundancy setting at its default value of 0. A packet redundancy
level can be assigned to improve packet delivery and robustness of FAX transport over
the network (with increased bandwidth as trade-off). Avaya uses IETF RFC-2198 and
ITU-T T.38 specifications as redundancy standard. With this standard, each Fax over
IP packet is sent with additional (redundant) 0 to 3 previous fax packets based on the
redundancy setting. A setting of 0 (no redundancy)
is suited for networks where packet
loss is not a problem .
display ip-codec-set 1 Page 2 of 2
IP Codec Set
Allow Direct-IP Multimedia? y
Maximum Call Rate for Direct-IP Multimedia: 2048:Kbits
Maximum Call Rate for Priority Direct-IP Multimedia: 2048:Kbits
Mode Redundancy
FAX t.38-standard 0
Modem off 0
TDD/TTY US 3
Clear-channel n 0