Operation, Warning – Poulan Pro BVM200C User Manual

Page 7

Advertising
background image

-- 7 --

OPERATION

KNOW YOUR BLOWER

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.

Compare the illustrations with your unit to familiarize yourself with the location of the various controls

and adjustments. Save this manual for future reference.

Start Lever

Fuel Mix

Fill Cap

Starter

Rope

Throttle

Trigger

Spark

Plug

Upper Blower Tube

Primer

Bulb

Vacuum Handle

Lower Vacuum Tube

Upper Vacuum Tube

Vacuum Bag

Elbow Tube

High--Speed

Nozzle

Lower Blower Tube

STOP

Switch

Throttle Position Lever

STOP SWITCH

The STOP switch is used to stop the engine.

To stop the engine, push and hold the STOP

switch in the STOP position until the engine

stops.

THROTTLE TRIGGER

The THROTTLE TRIGGER is used to select

the desired engine speed.

THROTTLE POSITION LEVER

The THROTTLE POSITION LEVER is de-

signed to allow setting engine speed during

blower use only. To avoid causing damage to

the unit, DO NOT attempt to use the throttle

position lever during vacuum use.

PRIMER BULB

The PRIMER BULB removes air from the car-

buretor and fuel lines and fills them with fuel.

This allows you to start the engine with fewer

pulls on the starter rope. Activate primer

bulbby pressing it and allowing it to return to

its original position.

CHOKE LEVER

The CHOKE helps to supply fuel to the engine

to aid in cold starting. Activate the choke by

moving the choke lever to the FULL CHOKE

position. After engine attempts to start, move the

choke lever to the HALF CHOKE position.

Once engine starts, move choke lever to the

RUN position.

OPERATING TIPS

WARNING:

While vacuuming or

blowing debris, hold the unit with the muffler

side facing away from your body and clothes

(see OPERATING POSITION .
S

To reduce the risk of hearing loss

associated with sound level(s), hearing

protection is required.

S

To reduce the risk of injury associated with

contacting rotating parts, stop the engine be-

fore installing or removing attachments. Do

not operate without guard(s) in place.

S

Operate power equipment only at reasonable

hours--not early in the morning or late at night

when people might be disturbed. Comply with

times listed in local ordinances. Usual recom-

mendations are 9:00 a.m. to 5:00 p.m.,

Monday though Saturday.

S

To reduce noise levels, limit the number of

pieces of equipment used at any one time.

S

To reduce noise levels, operate power

blowers at the lowest possible throttle

speed to do the job.

S

Use rakes and brooms to loosen debris be-

fore blowing.

S

In dusty conditions, slightly dampen sur-

faces or use a mister attachment when wa-

ter is available.

Advertising