Poulan Pro Pro 950 ZX 968999507 - Manual (Page 21)

English-
19
CONTROLS
4. By pass linkages
When pushing or pulling the mower, be sure
to engage the EZT (Integraded Zeroturn
Transaxle) bypass linkages. The EZT bypass
linkages are located on the rear of the frame,
below the rear engine guard.
• Raise the deck into the highest cutting
position.
• Pull the EZT bypass linkages out and
into the slots and release so that it is held
in the bypass position.
• To reengage the EZT’s to drive, reverse
the above procedure.
8011-721
1. EZT Bypass linkage
Bypass linkages
8011-722
1. Head outside of rear deck
2. EZT Bypass linkage in bypass position
Bypass position