PowerMadd Star Series 14250 Mounting Kit - Snow - Manual

Handguard Mounting Kit - Snow
Installation Instructions for Part No. 14250 (Snowmobiles)
HARDWARE INCLUDED: TOOLS REQUIRED:
Qty Description
• 3mm Hex Wrench
1 Straight Aluminum Bracket - throttle side
• 10mm Wrench (2)
1 Curved Aluminum Bracket -brake side
1 Steel Strap long – throttle side
1 Steel Strap short – brake side
2 M6 x 65mm Screws
2 M6 x 45mm Screws
2 M6 x 25mm Screws
2 M6 Lock Nuts
2 Square Nuts
2 M5 x 10mm Screws
2 Anti-spin Spacers
2 Long Spacers
READ ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLATION!
NOTE: PowerMadd’s brackets are designed to mount to the
bare handlebar in between the grip and the controls. Some
snowmobiles may require moving the throttle block and/or
brake master cylinder over and away from the grip to create a
space for the bracket to mount. You may even need to cut off
some of the grip, but be careful not to cut any hand warmer
wires.
THROTTLE SIDE BRACKET
STEP 1: Slide the steel strap onto the handlebars in between
the throttle block and the end of the grip. Any wires should go
outside the strap.
STEP 2: Attach the aluminum bracket to the strap by inserting
the short M5 screw and tighten it with a 3mm hex wrench.
STEP 3: Insert the M6 x 25mm screw through the bracket and
the strap. Thread it into the square nut and tighten. This
adjustment screw is used to achieve the desired tightness of the
mount. Leave the bracket loose enough for now so you can
adjust the position up or down after attaching the hand guard to
the bracket.
BRAKE SIDE BRACKET
STEP 4: Slide the steel strap onto the handlebars in between
where the brake master cylinder mounts to the handlebars and
the end of the grip. Any wires should go outside the strap.
STEP 5: Attach this bracket to the strap the same as in STEPS
2 & 3.
© 2010 PowerMadd IN14250
1-800-435-6881 www.powermadd.com