PowerMadd Seat Wedge – Arctic Cat F Series 51055 - Manual

POWERMADD
®
Seat Wedge – Arctic Cat F Series
Installation Instructions for 51055
TOOLS REQUIRED:
 Drill w/3/16” drill bit
 Pop rivet gun
 3/8 drive ratchet
 12”
extension
 7/16”
socket
 Tape measure

Marker
HARDWARE INCLUDED:
Item Qty Description
1 1 Seat Wedge
2 1 ¼-20 x 2” stud
3 1 ¼-20 flange nut
4 1 Fender Washer
5 4 Rivet 3/16”
6 2 3/16” rivet washer
PLEASE READ ALL INSTRUCTIONS
CAREFULLY PRIOR TO INSTALLATION
1. Remove the stock seat by going through the rear
storage compartment. See Figure 1. Remove the
factory nut and washer securing the stock seat. Set
stock seat, nut and washer aside for now.
2. Place Seat Wedge on the tunnel by tipping the
front of the Seat Wedge upwards and wrapping
the rear of the seat wedge around your tail light
then drop the front of the seat wedge so the stud in
the tunnel passes through the mounting hole in the
center of the seat wedge.
3. Once the Seat Wedge is placed on the tunnel, use
the hole on top of the seat wedge to locate the
existing stud and use the factory nut and washer to
secure the Seat Wedge. Figure 2
4. Once you have secured the seat wedge to the
tunnel locate the two molded round recesses in the
front of the seat wedge near your gas tank. In each
of the recesses using a 3/16” drill bit drill dead
center in the recess through the seat wedge and
your tunnel. Figure 3
Note: Use caution so you do not puncture your
track when drilling.
5. Install in each of the 3/16” drilled holes a 3/16”
rivet from the top side of the seat wedge through
the tunnel. Keep downward pressure on the rivet
and seat wedge while installing the rivets.
Figure 1
Figure 2
Figure 3