PROLiNK PPL1202N User Manual - Manual

www.prolink2u.com
PROLiNK ® PPL1202N
200Mbps Powerline Wireless-N Extender
Quick Installation Guide
Version 1.00 (Jul’10)
English
INSTALLATION & SETUP
The Overview:
The Front LEDs:
LED State Description
Powerline AP ON Powerline AP network activity.
OFF Search or no Powerline AP network activity.
Ethernet ON Ethernet connection is OK.
FLASHING Data transfer.
OFF
No link to Ethernet.
Wireless ON Wireless Function Enable
FLASHING Data transfer.
The Rear Connectors:
Connect an Ethernet cable from your PC's Ethernet port to the LAN port of the Powerline
200M Wireless-N Extender.
Connector Description
RJ-45 Port Connect to the Ethernet Cable
Secure Button Button can auto secure and group the Powerline AP devices.
Reset/WPS
Button WPS: Press 1 second can enable the WPS search function.
Reset: Press 5 seconds can reset the device to factory default.
Standby
Button Press this button to enable the standby mode (EuP/ErP function).
This function will stop the device activities in order to save energy.
CONFIGURING POWERLINE WITH WEB BROWSER
Before enter the web UI, please make sure your PC/NB's LAN TCP/IP settings should be in
the 192.168.16.x (x cannot be 168) IP domain, for example, you can set as "192.168.16.5"
and then follow the steps to enter the web management UI. Open web browser and type
http://192.168.16.168 in the browser's address box. This number is the default IP address for
this device. The default user name is “admin” and password is "password".
BROWSE THE USER'S MANUAL
Insert the CD into your CD-ROM, and the CD will be display with Auto-Run.
Register Online For Your Product Warranty.
www.prolink2u.com
IMPORTANT SAFETY INSTRUCTIONS
This product is intended for connection to the AC power line.
The following pre-cautions should be taken when using this product:
•
Please read all instructions before installing and operating this product.
• Please follow all warnings and instructions marked on the product.
• Do not operate this product near water.
• This product should never be place near or over radiator, or heat register.
• This product relies on a building's electrical installation for short-circuit (over
current) protection.
• Ensure that a fuse or circuit breaker is used on the phase conductors (all
current-carrying conductors).
• Do not allow anything to reset on the product interconnect cords.
• Do not locate this product where people may walk on the cords.
• The power cord should be plugged directly into a specification AC wall outlet.
• Only a qualified technician should service this product. Opening or removing
covers may result in exposure to dangerous voltage points or other risk.
• Unplug this product from the wall outlet and refer the product to qualified
service personal for the following conditions:
1. When the interconnect cords are damaged or frayed.
2. If liquid has been spilled onto the product.
3. If the product has been exposed to rain or water.
4. If the product does not operate normally when the operating instructions
have been followed.
5. If the product exhibits a distinct change in performance.